Title of your website

Version 7

Online manuals

3.2.Power wiring and device start-up #

Before you install and wire any device, make sure to disconnect the electric power from the system! Strip the ends of the cable so it could be slipped into the supplied green connector (as shown on the picture bellow). Do not forget to check the correct polarity! Tighten the terminal screw, using a small flat-blade screwdriver.


Please keep in mind the power input voltage must always be within the range of 12~48V DC!




When the wires are attached plug in the green connector to the green socket, located in the bottom right corner of the front panel and plug it into the electrical socket. The device automatically starts up and performs the initialization process, indicated by the LED status indicators.




Suggest Edit